Hyundai KIA SMARTRA 2 SMARTRA 3 Emulator

Product Overview: Permanent Solution to Chronic Smartra Failures

In Hyundai and Kia vehicles (i30, Accent, Rio, Cerato, Tucson, etc.), the "IMMOBILIZER" light failing to illuminate when the ignition is turned on, causing the engine to crank but not start, is a chronic issue.

The root cause of this failure is the deterioration over time of the vehicle's original SMARTRA 2 or SMARTRA 3 immobilizer module (key reader antenna).

This emulator is designed to permanently replace (bypass) the faulty original Smartra module. By stepping in for the defective unit, it restores the proper operation of the immobilizer system and resolves the "Immo light not turning on" issue.

⚠️ IMPORTANT PROFESSIONAL WARNING: PROGRAMMING IS REQUIRED

• NOT "Plug & Play": This emulator is NOT plug-and-play.

• NOT "Immo Off": This device does not disable the immobilizer system. It is a programmable replacement part that takes the place of the faulty Smartra module.

• VEHICLE PIN CODE REQUIRED: For the device to function, you must have the vehicle's specific 6-DIGIT SECURITY PIN CODE.

• KEY PROGRAMMING REQUIRED: Existing keys must be relearned (programmed) to the vehicle using a professional key programming tool (Autel, VVDI, AVDI, etc.).

Key Features and Benefits

• Permanent Solution: Permanently replaces the failure-prone original Smartra module.

• Original Socket Compatible: Extremely easy to install. Simply disconnect the original Smartra module socket and plug it directly into this emulator. No soldering or wire cutting required.

• Broad Programmer Support: Fully compatible with all professional devices capable of programming Hyundai/Kia keys.

• Cost Savings: Eliminates the necessity of ordering and waiting for an expensive replacement Smartra module from authorized dealerships.

• Uses Existing Keys: No new keys or transponder chips are needed; the vehicle's original keys are simply reprogrammed to this emulator.

Step-by-Step Installation and Programming

1. Locate the vehicle's original Smartra module (typically around the ignition barrel).

2. Disconnect the original Smartra socket.

3. Plug this emulator into the disconnected original socket.

4. Connect your professional key programming tool (Autel, VVDI, Obdstar, etc.) to the vehicle's OBD port.

5. Navigate to the "New Key Programming" menu on your device.

6. Enter the 6-digit Vehicle PIN Code when prompted by the system.

7. Program the existing keys (old/original keys) to the emulator one by one by inserting them into the ignition (or by following the on-screen prompts of your device).

8. Once programming is complete, verify that the IMMOBILIZER light turns on and the vehicle starts successfully.

Compatible Vehicle List (Smartra 2 & 3)